Amana Washer Leaving Clothes Soaking Wet? Try these FIXES!

Is your Amana washer still leaving clothes soaking wet?

I know lifting dripping clothes from the drum is frustrating and makes drying take much longer. I would begin by asking you to check the spin setting, load balance, and drain, since a slow drain or an uneven load can stop the washer from reaching full spin speed.

Simple Checks for Soaking Wet Amana Laundry

Start with the everyday causes. When an Amana washer leaves clothes soaking wet, check spin speed, balance the load, reduce suds, clear the drain, and test spin strength.

So, use this guide when clothes are still wet after spin cycle, the Amana washer is not spinning clothes dry, or clothes are too wet after wash.

Check for Foam After the Wash

In many cases, too much detergent makes foam that cushions the Amana laundry and keeps the machine from pulling water out well. Use the detergent type and amount in the manual.

At this point, run an extra rinse without more soap if foam remains. It may take another rinse before a heavily soaped load spins normally.

There is usually a few clues around the Amana soap level before the next test.

Arrange Service for a Slow Drum

Also, if the Amana washer is not spinning clothes dry, listen from a safe distance during an empty spin. A drum that never reaches speed may have a drive, motor, suspension, or control problem.

Before this check, do not use the machine if it grinds, leaks, or smells hot. Ask a technician to test it instead of ordering a part from the symptom alone.

However, this guide covers clothes too wet after wash even though spin runs. If the drum never moves, see why the Amana washer drum is not turning.

These spin drive is also worth your attention while the washer is empty.

Remove Items From a Packed Drum

Before moving on, separate tangled items in the Amana drum and spread heavy pieces around it. Remove some laundry if the tub is packed.

In many cases, a single wet blanket can throw the load off balance and shorten the spin. Stop the machine if it bangs, then rearrange the clothes.

The simple signs around this wet load is easy to miss as you check the simple causes.

Review the Fabric Cycle

As you work, check the cycle selected on the Amana washer. A delicate, hand wash, or low spin choice leaves more water in fabric than a normal or faster spin.

Before moving on, choose the highest speed that is safe for the clothes, then run a drain and spin cycle. Protect delicate fabric by following its care label.

The Amana may gives you a useful clue around this spin setting before you try a harder repair.

Straighten the Drain Hose

At this point, a slow drain leaves water in the Amana tub when spin begins. Straighten the hose and remove only a blockage you can reach safely.

So, if the manual shows a user accessible filter, unplug the washer, prepare for water, and clean it as directed. More drain checks are in our guide to an Amana washer that is not draining.

Conclusion

The simple checks above should help you get drier laundry or decide whether the Amana needs service.

• Check for Foam After the Wash
• Arrange Service for a Slow Drum
• Remove Items From a Packed Drum
• Review the Fabric Cycle
• Straighten the Drain Hose