Easy Ways to Fix a Frigidaire Washer that is Not Dispensing Detergent

Is your Frigidaire washer not dispensing detergent?

I know detergent left in the drawer means your clothes may not get a proper wash. I would check the detergent amount, drawer channels, and water flow. In my experience, dried soap or weak water flow can keep detergent in the drawer.

Why Isn't My Frigidaire Washer Dispensing Detergent?

The usual causes are simple. To fix a Frigidaire washer not dispensing detergent, use the right soap, clean and refit the drawer, check water flow, and level the machine.

Before moving on, the same checks help when the Frigidaire washer is not dispensing soap, has a drawer full of water, has a drawer stuck, or is leaving detergent in the drawer.

Open the Supply Taps Fully

For this check, open the supply taps and straighten the inlet hoses behind the Frigidaire washer. Weak water flow may leave detergent in the drawer instead of rinsing it into the tub.

Take care here: turn off the water and unplug the machine before removing a hose. If the washer also fills slowly, see why the Frigidaire washer is not filling with water.

The Frigidaire may gives you a useful clue around this water flow before the next test.

Wash Every Drawer Channel

Take care here: unplug the Frigidaire washer. Never force a drawer that is stuck; use the release shown in the manual for your exact model.

Next, follow these steps to remove the buildup:

1. Pull the drawer out until it stops.
2. Press the release shown in the manual and lift the drawer free.
3. Remove loose inserts and soak them in warm water.
4. Scrub each channel with a soft brush, then rinse it.
5. Wipe the empty housing and dry every part before refitting it.

As you work, clear only loose residue from the small water holes. Do not push a sharp object into them.

There is usually a few clues around the Frigidaire detergent drawer while the washer is empty.

Check the Main Wash Compartment

Remember, put detergent in the Frigidaire compartment marked for the main wash, not the bleach or softener section. Use the type required by the manual and measure it for the load.

Besides this, too much detergent can form a thick paste. Liquid filled above a marked line may also drain too early or remain after the wash.

These detergent choice is also worth your attention as you check the simple causes.

Check the Softener Insert

Next, push every clean insert fully into its matching Frigidaire drawer compartment. A loose siphon cap can leave the drawer full of water or stop softener from leaving.

For this check, compare the pieces with the diagram in the manual if the drawer does not slide freely after cleaning.

The simple signs around this drawer insert is easy to miss before you try a harder repair.

Check the Washer Angle

As you work, a badly tilted Frigidaire washer can leave water sitting at one side of the drawer. Adjust the feet until the cabinet is level and steady.

In many cases, if water never reaches a clean drawer, an inlet valve, passage, or control may be faulty. Ask a technician to test it, and contact Frigidaire first if the machine is under warranty.

At this point, if odor remains after the drawer is clean, read how to clean a Frigidaire washer that smells bad.

Conclusion

Use what the Frigidaire washer is doing to choose the most useful check and get a drawer that empties properly.

• Open the Supply Taps Fully
• Wash Every Drawer Channel
• Check the Main Wash Compartment
• Check the Softener Insert
• Check the Washer Angle