Hotpoint Washing Machine Leaves Clothes Soaking Wet? Here's How to Fix It

Does your Hotpoint washing machine keep leaving clothes soaking wet?

I would suggest starting with the checks you can do safely. I think you should check the spin setting, load balance, and drain, because a slow drain or an uneven load can stop the washer from reaching full spin speed.

What to Check When a Hotpoint Washing Machine Leaves Wet Clothes

I would check the easy causes first. When a Hotpoint washing machine leaves clothes soaking wet, check spin speed, balance the load, reduce suds, clear the drain, and test spin strength.

Also, use this guide when clothes are still wet after spin cycle, the Hotpoint washing machine is not spinning clothes dry, or clothes are too wet after wash.

Spread the Laundry Evenly

As you work, separate tangled items in the Hotpoint drum and spread heavy pieces around it. Remove some laundry if the tub is packed.

Before moving on, a single wet blanket can throw the load off balance and shorten the spin. Stop the machine if it bangs, then rearrange the clothes.

A small wet load problem on the Hotpoint often cause a much bigger symptom while you look for the cause.

Inspect the Drain Path

In many cases, a slow drain leaves water in the Hotpoint tub when spin begins. Straighten the hose and remove only a blockage you can reach safely.

Also, if the manual shows a user accessible filter, unplug the washing machine, prepare for water, and clean it as directed. More drain checks are in our guide to a Hotpoint washing machine that is not draining.

The drain path on your Hotpoint sometimes need only a simple correction before you decide on service.

Try a Drain and Spin Cycle

For this check, check the cycle selected on the Hotpoint washing machine. A delicate, hand wash, or low spin choice leaves more water in fabric than a normal or faster spin.

As you work, choose the highest speed that is safe for the clothes, then run a drain and spin cycle. Protect delicate fabric by following its care label.

This spin setting problem sometimes come and go on a Hotpoint as you compare each result.

Check the Drive Parts Safely

At this point, if the Hotpoint washing machine is not spinning clothes dry, listen from a safe distance during an empty spin. A drum that never reaches speed may have a drive, motor, suspension, or control problem.

As a safety step, do not use the machine if it grinds, leaks, or smells hot. Ask a technician to test it instead of ordering a part from the symptom alone.

So, this guide covers clothes too wet after wash even though spin runs. If the drum never moves, see why the Hotpoint washing machine drum is not turning.

This part around the spin drive often get forgotten on a Hotpoint washing machine while you work through the list.

Rinse Away Too Much Soap

Before moving on, too much detergent makes foam that cushions the Hotpoint laundry and keeps the machine from pulling water out well. Use the detergent type and amount in the manual.

In many cases, run an extra rinse without more soap if foam remains. It may take another rinse before a heavily soaped load spins normally.

Conclusion

Work through the Hotpoint checks in the order that matches what you see, aiming for drier laundry.

• Spread the Laundry Evenly
• Inspect the Drain Path
• Try a Drain and Spin Cycle
• Check the Drive Parts Safely
• Rinse Away Too Much Soap