Whirlpool Washer Leaves Clothes Soaking Wet? Here's How to Fix It

Is your Whirlpool washer leaving clothes soaking wet?

I often find that a slow drain or an uneven load can stop the washer from reaching full spin speed. I would check the spin setting, load balance, and drain before thinking about a major repair.

How to Dry Clothes Better in a Whirlpool Washer

When a Whirlpool washer leaves clothes soaking wet, check spin speed, balance the load, reduce suds, clear the drain, and test spin strength.

Remember, use this guide when clothes are still wet after spin cycle, the Whirlpool washer is not spinning clothes dry, or clothes are too wet after wash.

Choose a Faster Spin

At this point, check the cycle selected on the Whirlpool washer. A delicate, hand wash, or low spin choice leaves more water in fabric than a normal or faster spin.

Also, choose the highest speed that is safe for the clothes, then run a drain and spin cycle. Protect delicate fabric by following its care label.

These spin setting is also worth your attention before you try a harder repair.

Clear the Drain Hose and Filter

However, a slow drain leaves water in the Whirlpool tub when spin begins. Straighten the hose and remove only a blockage you can reach safely.

Remember, if the manual shows a user accessible filter, unplug the washer, prepare for water, and clean it as directed. More drain checks are in our guide to a Whirlpool washer that is not draining.

The simple signs around this drain path is easy to miss while you look over the machine.

Balance and Reduce the Load

Also, separate tangled items in the Whirlpool drum and spread heavy pieces around it. Remove some laundry if the tub is packed.

So, a single wet blanket can throw the load off balance and shorten the spin. Stop the machine if it bangs, then rearrange the clothes.

The Whirlpool may gives you a useful clue around this wet load as you inspect it.

Have a Weak Spin Checked

Further, if the Whirlpool washer is not spinning clothes dry, listen from a safe distance during an empty spin. A drum that never reaches speed may have a drive, motor, suspension, or control problem.

For safety, do not use the machine if it grinds, leaks, or smells hot. Ask a technician to test it instead of ordering a part from the symptom alone.

Besides this, this guide covers clothes too wet after wash even though spin runs. If the drum never moves, see why the Whirlpool washer drum is not turning.

There is usually a few clues around the Whirlpool spin drive during your first check.

Reduce Excess Suds

So, too much detergent makes foam that cushions the Whirlpool laundry and keeps the machine from pulling water out well. Use the detergent type and amount in the manual.

However, run an extra rinse without more soap if foam remains. It may take another rinse before a heavily soaped load spins normally.

Conclusion

Use what the Whirlpool washer is doing to choose the most useful check and get drier laundry.

• Choose a Faster Spin
• Clear the Drain Hose and Filter
• Balance and Reduce the Load
• Have a Weak Spin Checked
• Reduce Excess Suds