Fisher & Paykel Washer Stops Mid-Cycle? Try These Fixes

Is your Fisher & Paykel washer stopping in the middle of a cycle? I know this is frustrating when the clothes are left soaking wet.

Luckily, you can check the load, drain, and lid yourself. I would do that before paying for a repair.

What Makes a Fisher & Paykel Washer Stop Mid-Cycle?

Balance the load, check the drain and lid, reset the power, then have the controls tested.

Balance the Clothes

Spread heavy items around the tub and remove some if it is too full. An uneven load are a common cause.

Check the Drain Hose

Straighten the hose and clear a blockage. If water stays inside, read about a Fisher & Paykel washer that is not draining. These check is important before spin.

Close the Lid or Door

Move clothes from the edge, clean the latch, and close it gently. A faulty lock may needs replacement and must not be bypassed.

Reset the Power

Disconnect the washer for five minutes. Turn it back on, select a quick wash, and note what it is doing if it stops again.

Have the Controls Tested

If it stops at the same point each time, there is several parts a technician may need to test.

Conclusion

• Balance the clothes
• Check the drain hose
• Close the lid or door
• Reset the power
• Have the controls tested