Frigidaire Washer Not Heating Water? Try these FIXES!

Have you noticed that your Frigidaire washer is not heating up water?

I think the simple checks are the right place to start. I would check the selected temperature, hot water supply, and inlet hose, because a wrong setting, closed supply tap, or bent inlet hose can leave the washer with cold water.

Why Is My Frigidaire Washer Washing in Cold Water?

The usual causes are simple. To fix a Frigidaire washer not heating water, check the cycle, water supply, inlet hose and screens, then have the heating parts tested.

So, if your Frigidaire washer won't heat water, note whether it is washing in cold water only or the water is not getting hot on every warm cycle.

Straighten the Water Hose

In many cases, follow each inlet hose behind the Frigidaire washer. Straighten sharp bends, free a hose trapped against the wall, and make sure the connections match the labels on the machine.

Take care here: turn off the water before moving a connection. Replace a hose that is split, swollen, or leaking instead of trying to patch it.

This inlet hose problem sometimes come and go on a Frigidaire while you look over the machine.

Ask for an Inlet Valve Test

Also, if the water is not getting hot after the supply checks, the inlet valve, heater, temperature sensor, wiring, or control may be at fault. Which parts apply depends on the Frigidaire model.

Take care here: keep the machine unplugged and ask a qualified technician to test it. Contact Frigidaire first if the washer is under warranty.

This part around the heating part often get forgotten on a Frigidaire washer as you inspect it.

Open the Hot Water Tap

Before moving on, check the manual to see whether your Frigidaire washer uses separate hot and cold hoses or heats a cold supply inside the machine. If it has a hot hose, open that tap fully and run the nearest hot sink tap.

In many cases, if the nearby tap stays cold, the trouble is in the household hot water supply. A single inlet model needs a technician if its internal heating parts do not warm the wash.

A small hot water supply problem on the Frigidaire often cause a much bigger symptom during your first check.

Choose a Warm Cycle

As you work, select a normal warm or hot cycle instead of a cold, delicate, or energy saving option. Let the Frigidaire washer complete an empty test cycle without opening it while it runs.

Before moving on, some cycles use cooler water to protect fabric. Compare the choice with the cycle chart in your manual before deciding the washer will not heat.

The cycle setting on your Frigidaire sometimes need only a simple correction while you look for the cause.

Rinse Dirt From the Water Screens

At this point, small screens where the hoses meet the Frigidaire washer catch grit. A blocked hot side can leave the machine washing in cold water only even when cold filling looks normal.

Take care here: unplug the washer, close the taps, and follow the manual before removing a hose. Rinse loose dirt gently, do not pull the screen out, and check every connection for leaks afterward.

So, if both supplies are weak, read about a Frigidaire washer that is not filling with water.

Conclusion

Work through the Frigidaire checks in the order that matches what you see, aiming for warmer wash water.

• Straighten the Water Hose
• Ask for an Inlet Valve Test
• Open the Hot Water Tap
• Choose a Warm Cycle
• Rinse Dirt From the Water Screens