Kenmore Washer Not Heating Water? Try these FIXES!

Is your Kenmore washer not heating up water?

I know a warm cycle that stays cold can make you think the heater has failed. I would start by asking you to check the selected temperature, hot water supply, and inlet hose, as a wrong setting, closed supply tap, or bent inlet hose can leave the washer with cold water.

Why Isn't My Kenmore Washer Heating Water?

Begin with the safe checks. To fix a Kenmore washer not heating water, check the cycle, water supply, inlet hose and screens, then have the heating parts tested.

At this point, if your Kenmore washer won't heat water, note whether it is washing in cold water only or the water is not getting hot on every warm cycle.

Try Another Warm Wash Setting

Next, select a normal warm or hot cycle instead of a cold, delicate, or energy saving option. Let the Kenmore washer complete an empty test cycle without opening it while it runs.

For this check, some cycles use cooler water to protect fabric. Compare the choice with the cycle chart in your manual before deciding the washer will not heat.

These cycle setting is also worth your attention during your first check.

Check the Hot Inlet Path

As you work, follow each inlet hose behind the Kenmore washer. Straighten sharp bends, free a hose trapped against the wall, and make sure the connections match the labels on the machine.

Before touching anything, turn off the water before moving a connection. Replace a hose that is split, swollen, or leaking instead of trying to patch it.

The simple signs around this inlet hose is easy to miss while you look for the cause.

Clean a Blocked Supply Screen

Before moving on, small screens where the hoses meet the Kenmore washer catch grit. A blocked hot side can leave the machine washing in cold water only even when cold filling looks normal.

Before touching anything, unplug the washer, close the taps, and follow the manual before removing a hose. Rinse loose dirt gently, do not pull the screen out, and check every connection for leaks afterward.

At this point, if both supplies are weak, read about a Kenmore washer that is not filling with water.

The Kenmore may gives you a useful clue around this inlet screen before you decide on service.

Confirm How the Washer Receives Hot Water

For this check, check the manual to see whether your Kenmore washer uses separate hot and cold hoses or heats a cold supply inside the machine. If it has a hot hose, open that tap fully and run the nearest hot sink tap.

As you work, if the nearby tap stays cold, the trouble is in the household hot water supply. A single inlet model needs a technician if its internal heating parts do not warm the wash.

There is usually a few clues around the Kenmore hot water supply as you compare each result.

Arrange a Safe Heating System Check

In many cases, if the water is not getting hot after the supply checks, the inlet valve, heater, temperature sensor, wiring, or control may be at fault. Which parts apply depends on the Kenmore model.

Before touching anything, keep the machine unplugged and ask a qualified technician to test it. Contact Kenmore first if the washer is under warranty.

Conclusion

Use what the Kenmore washer is doing to choose the most useful check and get warmer wash water.

• Try Another Warm Wash Setting
• Check the Hot Inlet Path
• Clean a Blocked Supply Screen
• Confirm How the Washer Receives Hot Water
• Arrange a Safe Heating System Check