Hotpoint Washing Machine Stops Mid-Cycle? Try These Fixes

Is your Hotpoint washing machine stopping halfway through a cycle? I know how frustrating it is to find wet clothes still sitting in the drum.

Luckily, this is usually caused by a water, drain, load, or door problem. The point where it stops will tell you which one to check first.

Follow each one before you assume the control board has failed.

Why Does My Hotpoint Washer Stop Mid-Cycle?

If your Hotpoint washing machine stops mid-cycle, check the water and drain hoses, balance the load, close the door, and reset the washer.

Disconnect power before touching a hose or latch.

Check the Water Supply

Open both faucets and straighten the inlet hoses. Slow water are one reason a washer waits and then stops.

If the tub stays dry, see why your Hotpoint washer is not filling.

Check the Drain Hose

Remove bends and check for a blockage. Water left inside can stop the washer before spin.

Read our guide about a Hotpoint washer that is not draining. A blocked hose need cleaning before another cycle.

Balance the Load

Spread heavy clothes around the drum and remove some if it is too full. These check helps when the washer shakes before stopping.

If the cycle continues but the drum or agitator stays still, check why the Hotpoint washing machine drum is not turning.

Make Sure the Door Locks

Look around the door seal for a trapped sock or other small item. Wipe the latch clean, then shut the door gently.

Do not bypass a faulty door lock. If it looks fine, reset the washer and watch the next short cycle.

Try One Reset Before Calling for Help

Switch the washer off and unplug it. After five minutes, reconnect it and follow these steps to reset your Hotpoint washer.

If it always stops in the same place, there is several controls that may need testing. Call a technician rather than guessing.

Conclusion

Try these five fixes for a Hotpoint washer that stops mid-cycle:

• Check the water supply
• Check the drain hose
• Balance the load
• Make sure the door locks
• Try one reset before calling for help