Speed Queen Washer Not Dispensing Detergent? Try these FIXES!

Is your Speed Queen washer still not dispensing detergent?

I think the best place to begin is with the simple checks. I would check the detergent amount, drawer channels, and water flow, since dried soap or weak water flow can keep detergent in the drawer.

How to Fix a Speed Queen Washer Detergent Drawer

First, check the simple causes. To fix a Speed Queen washer not dispensing detergent, use the right soap, clean and refit the drawer, check water flow, and level the machine.

As you work, the same checks help when the Speed Queen washer is not dispensing soap, has a drawer full of water, has a drawer stuck, or is leaving detergent in the drawer.

Refit the Siphon Parts

Besides this, push every clean insert fully into its matching Speed Queen drawer compartment. A loose siphon cap can leave the drawer full of water or stop softener from leaving.

Next, compare the pieces with the diagram in the manual if the drawer does not slide freely after cleaning.

This part around the drawer insert often get forgotten on a Speed Queen washer while you look for the cause.

Use the Correct Detergent

Further, put detergent in the Speed Queen compartment marked for the main wash, not the bleach or softener section. Use the type required by the manual and measure it for the load.

Remember, too much detergent can form a thick paste. Liquid filled above a marked line may also drain too early or remain after the wash.

A small detergent choice problem on the Speed Queen often cause a much bigger symptom before you decide on service.

Remove and Clean the Drawer

With safety in mind, unplug the Speed Queen washer. Never force a drawer that is stuck; use the release shown in the manual for your exact model.

Besides this, follow these steps to remove the buildup:

1. Pull the drawer out until it stops.
2. Press the release shown in the manual and lift the drawer free.
3. Remove loose inserts and soak them in warm water.
4. Scrub each channel with a soft brush, then rinse it.
5. Wipe the empty housing and dry every part before refitting it.

For this check, clear only loose residue from the small water holes. Do not push a sharp object into them.

The detergent drawer on your Speed Queen sometimes need only a simple correction as you compare each result.

Level the Washer and Test the Valve

For this check, a badly tilted Speed Queen washer can leave water sitting at one side of the drawer. Adjust the feet until the cabinet is level and steady.

Before moving on, if water never reaches a clean drawer, an inlet valve, passage, or control may be faulty. Ask a technician to test it, and contact Speed Queen first if the machine is under warranty.

In many cases, if odor remains after the drawer is clean, read how to clean a Speed Queen washer that smells bad.

This washer level problem sometimes come and go on a Speed Queen while you work through the list.

Check Water Flow to the Drawer

Next, open the supply taps and straighten the inlet hoses behind the Speed Queen washer. Weak water flow may leave detergent in the drawer instead of rinsing it into the tub.

With safety in mind, turn off the water and unplug the machine before removing a hose. If the washer also fills slowly, see why the Speed Queen washer is not filling with water.

Conclusion

These Speed Queen checks move from simple causes of the problem to repairs that need professional help for a drawer that empties properly.

• Refit the Siphon Parts
• Use the Correct Detergent
• Remove and Clean the Drawer
• Level the Washer and Test the Valve
• Check Water Flow to the Drawer