Maytag Washer Shaking and Moving? Try these FIXES!

So, your Maytag washer is shaking or moving every time it spins? Watching it vibrate badly or walk across the floor is worrying, and it can pull on the hoses.

Don't worry. If you want to know how to stop it moving, start with the floor, feet, and wash load. Turn the washer off if it is shaking violently and check it before running another load.

How to Stop a Maytag Washer From Shaking

To stop a Maytag washer shaking or moving, steady the floor, level its feet, balance the load, check installation, and inspect the suspension safely.

Keep some space between the washer and nearby cabinets. The machine should not rely on a wall to hold it still, and its hoses must have enough room to move without stretching.

Check the Floor and Clearance

Place the washer on a hard, solid surface. A soft mat, loose board, or weak floor can make the washer start vibrating badly during spin.

These surface should feel firm when you stand beside the washer. If the floor moves under your weight, have it checked before trying to adjust the appliance around it.

Level All Four Feet

Unplug the washer, then press down gently on each top corner. Adjust the feet until the cabinet does not rock and every foot stays in full contact with the floor.

Loose feet is a common reason a Maytag washer starts walking across the floor. Tighten the locking nuts after leveling if your washer has them, using the instructions for your model.

Balance and Reduce the Load

Untangle the clothes and spread heavy pieces around the drum. Do not wash one absorbent rug or blanket by itself, and remove items if the drum is tightly packed.

A mixed loads may settle more evenly than one heavy item. If the washer becomes stable with an empty spin, load balance is the likely cause.

Check a Recent Installation

If the washer has shaken since it was installed or moved, compare the setup with the installation guide. Make sure all shipping materials specified for removal are gone and that the drain hose and power cord are not trapped beneath a foot.

Do not guess which bolts or braces to remove. The installation instructions for your exact model shows the correct shipping parts.

Have the Suspension Inspected

Springs, rods, or shock absorbers help control drum movement, depending on the washer design. When one wears out, the tub may bounce, lean, or hit the cabinet even with a small balanced load.

If the main symptom is a knock or rumble rather than movement, read how to check a Maytag washer making a loud noise during spin.

Suspension work involves heavy moving parts. Ask a technician to inspect the washer, and contact Maytag first if it is still under warranty.

Conclusion

You can often stop the movement without replacing a part. Work through these five fixes:

• Check the floor and clearance
• Level all four feet
• Balance and reduce the load
• Check a recent installation
• Have the suspension inspected