Zanussi Washing Machine Stops Mid-Cycle? Try These 5 Fixes

So, your Zanussi washing machine stops before the cycle is finished? This can be very frustrating when the clothes are still wet and the door will not open.

Luckily, the last sound you heard gives you a useful clue. The load, drain, water supply, and door are all easy to check at home.

Follow the five solutions below, and one should help you find why the washer keeps stopping.

What to Check When a Zanussi Washer Stops Mid-Cycle

If your Zanussi washer stops mid-cycle, check the load, drain hose, water supply, and door, then reset the washer or have its controls tested.

Unplug the washer before touching a hose or door latch. If it is under warranty, do not remove the control panel.

Balance the Clothes

Open the drum and spread heavy clothes around it. Remove a few items if the washer is packed tightly.

An uneven load are one of the common reasons a washer stops before spinning. These check is especially useful if it shakes first.

Check the Drain Hose

Straighten the hose and make sure it is not trapped behind the washer. Clear a blockage if you can safely reach it.

If water stays in the drum, read our guide about a Zanussi washer that is not draining. A blocked hose may needs cleaning before the washer can spin.

Check the Water Supply

Open the water faucet fully and remove bends from the inlet hose. A washer may stop if it cannot get enough water for the rinse.

There may be small amount of dirt in the inlet screen. Turn off the power and water before cleaning it.

Make Sure the Door Locks

Move clothes away from the seal, wipe detergent from the latch, and close the door gently. Do not try to bypass the door lock.

If the door is secure, a reset is the last safe check to make at home.

Give the Washer One Fresh Start

Disconnect the washer for five minutes, then reconnect it. Follow these instructions to reset a Zanussi washing machine and run a quick wash.

If it stops at the same point again, there is several controls a technician may need to test.

Conclusion

Try these five fixes when your Zanussi washer stops mid-cycle:

• Balance the clothes
• Check the drain hose
• Check the water supply
• Make sure the door locks
• Give the washer one fresh start

Start with the load and drain because they are the easiest places to check.